Intergas error codes
What the codes on your Intergas cv-ketel mean (Xtreme, Kombi Kompakt HRE, Prestige, HReco), what you can safely do yourself and when you need an engineer.
Where do you see the code?
With a fault the service symbol flashes and the code shows on the left display for about 30 seconds. Tap the flashing symbol to see it again.
Reset
Hold the flashing service button for 2 seconds; the boiler then restarts.
The Xtreme shows low pressure as a flashing pressure value, without a code. Below 0.5 bar the boiler works in limited mode.
All codes
- F004Burner doesn't igniteThe Xtreme tries to ignite, but the burner doesn't come on.Engineer needed
- N152Flue gas sensor faultA notice about the flue gas sensor. It disappears once the boiler can recover by itself.Engineer needed
- N030Hot tap water blockedA notice, not a fault: drawing hot water is temporarily blocked. The notice disappears once the boiler can recover by itself.Often fixable yourself
- N202Burner switched offA notice that the burner has been temporarily switched off. It disappears once the boiler can recover by itself.Often fixable yourself
Questions about Intergas
How do I reset my Intergas cv-ketel?
Hold the flashing service button for 2 seconds; the boiler then restarts.
Where is the fault code shown on my Intergas?
With a fault the service symbol flashes and the code shows on the left display for about 30 seconds. Tap the flashing symbol to see it again.
Which Intergas faults can I fix myself?
N030 (hot tap water blocked), N202 (burner switched off): the page for each code lists the steps you can safely do yourself.
Other brands central heating boilers
Checked in 11-2026. Codes can differ per model; if in doubt, check the manual of your appliance.