Nefit error codes
What the codes on your Nefit cv-ketel mean (EcomLine, TopLine, TrendLine, ProLine, Nefit 1200), what you can safely do yourself and when you need an engineer.
Where do you see the code?
Nefit boilers show a two-character code on the display, sometimes followed by a number (the subcode), for example 6A or EA 227.
Reset
Hold the reset button for a few seconds until the display shows 'rE' or 'reset'. If the code comes back, call an engineer.
All codes
- 6ANo flame after ignitionThe boiler tries to ignite but sees no flame. Often a closed gas tap, a dirty igniter or a blocked condensate drain.Engineer needed
- EANo flame detectedThe boiler sees no flame (on newer boilers often with subcode 227). The cause is usually the same as with 6A: gas supply, ignition or flue.Engineer needed
- H28Hot water maintenance noticeA maintenance notice on the TrendLine II: the boiler keeps working as normal. Possible causes are a dirty heat exchanger or too much hot water at once.Engineer needed
- 2PFlow temperature rising too fastThe water in the boiler heats up faster than normal. That's due to too little flow: air, low pressure, closed valves or a faltering pump.Often fixable yourself
- H07Water pressure too lowThe water pressure in the central heating system is too low. The boiler warns or stops to prevent damage.Often fixable yourself
Questions about Nefit
How do I reset my Nefit cv-ketel?
Hold the reset button for a few seconds until the display shows 'rE' or 'reset'. If the code comes back, call an engineer.
Where is the fault code shown on my Nefit?
Nefit boilers show a two-character code on the display, sometimes followed by a number (the subcode), for example 6A or EA 227.
Which Nefit faults can I fix myself?
H07 (water pressure too low), 2P (flow temperature rising too fast): the page for each code lists the steps you can safely do yourself.
Other brands central heating boilers
Checked in 11-2026. Codes can differ per model; if in doubt, check the manual of your appliance.