Vaillant cv-ketel
Fault F.62: gas valve closes too slowly
The flame stays visible too long after switching off. The gas valve doesn't close properly.
Do this first
- Turn the boiler off.
- Smell gas? Don't touch any switches, open windows and doors, go outside and call 0800-9009 (the national emergency number for gas and power).
When should you call an engineer?
Call an engineer and leave the boiler off until it's been checked.
Reset
Press the reset button once (on most ecoTEC models the button with the arrows or 'reset'). If the boiler goes into fault again, don't keep resetting but call an engineer.
Still under warranty?
Add your cv-ketel to your home file, with the installation date. Then you'll see whether it's still under warranty and get a reminder for servicing.
Add applianceFrequently asked questions
What does F.62 mean on a Vaillant cv-ketel?
The flame stays visible too long after switching off. The gas valve doesn't close properly.
Can I fix F.62 myself?
Turn the boiler off. Smell gas? Don't touch any switches, open windows and doors, go outside and call 0800-9009 (the national emergency number for gas and power). Call an engineer and leave the boiler off until it's been checked.
Other Vaillant codes
- F.22 too little water in the boiler
- F.28 ignition failed
- F.29 flame goes out while burning
- F.75 no pressure difference when the pump starts
- F.20 overheating
- F.00 flow sensor interrupted
- F.01 return sensor interrupted
- F.10 flow sensor short circuit
- F.27 flame detected while the gas valve is closed
- F.61 fault in the gas valve control
- F.63 memory error (eeprom)
- F.64 fault in electronics or sensor
- F.73 pressure sensor signal too low
- F.83 dry firing at burner start
Checked in 11-2026. Codes can differ per model; if in doubt, check the manual of your appliance.