Vaillant cv-ketel
Fault F.63: memory error (eeprom)
The boiler's electronics can't read its settings.
Do this first
- Disconnect the boiler from the power for a minute and turn it on again.
When should you call an engineer?
If F.63 comes back, the circuit board has to be replaced.
Reset
Press the reset button once (on most ecoTEC models the button with the arrows or 'reset'). If the boiler goes into fault again, don't keep resetting but call an engineer.
Still under warranty?
Add your cv-ketel to your home file, with the installation date. Then you'll see whether it's still under warranty and get a reminder for servicing.
Add applianceFrequently asked questions
What does F.63 mean on a Vaillant cv-ketel?
The boiler's electronics can't read its settings.
Can I fix F.63 myself?
Disconnect the boiler from the power for a minute and turn it on again. If F.63 comes back, the circuit board has to be replaced.
Other Vaillant codes
- F.22 too little water in the boiler
- F.28 ignition failed
- F.29 flame goes out while burning
- F.75 no pressure difference when the pump starts
- F.20 overheating
- F.00 flow sensor interrupted
- F.01 return sensor interrupted
- F.10 flow sensor short circuit
- F.27 flame detected while the gas valve is closed
- F.61 fault in the gas valve control
- F.62 gas valve closes too slowly
- F.64 fault in electronics or sensor
- F.73 pressure sensor signal too low
- F.83 dry firing at burner start
Checked in 11-2026. Codes can differ per model; if in doubt, check the manual of your appliance.